Starting explorer 8.8 swap soon..final ???
#1
Starting explorer 8.8 swap soon..final ???
I have the axle and all hardware, Im good with that. I need to know some final stuff. My truck is a 99 4x4 with 4:10 open diff and 4wabs. The explorer donor is a 98 with 4:10 and an open diff. I need to know
1. Is my 4 wheel abs going to work with the new rear axle or am I going to need to worry about adapters or new sensors?
2. Will I need to swap out my master cyl for an explorers?
3. Will I need to install a proportioning valve for the brake system?
Although I appreciate all input, I would love to hear from the guys that have done this mod. The are important and potentionally expensive steps and I want to make sure Im not going to screw something up. I dont mind the extra time on doing this right the first time. Any other pointers are welcome also. Thanks,
Parker
1. Is my 4 wheel abs going to work with the new rear axle or am I going to need to worry about adapters or new sensors?
2. Will I need to swap out my master cyl for an explorers?
3. Will I need to install a proportioning valve for the brake system?
Although I appreciate all input, I would love to hear from the guys that have done this mod. The are important and potentionally expensive steps and I want to make sure Im not going to screw something up. I dont mind the extra time on doing this right the first time. Any other pointers are welcome also. Thanks,
Parker
Thread
Thread Starter
Forum
Replies
Last Post
smokindmax
SOHC - 2.3L & 2.5L Lima Engines
5
09-01-2009 10:33 AM
DaneTrain
General Technical & Electrical
2
09-26-2006 04:58 PM