Changing out Cam Position Sensor - Hall Effect
#1
Changing out Cam Position Sensor - Hall Effect
A new Cam Sensor arrived and it looks to be the correct component.
I thought this would be an easy removal/installation, but after removing the distributor wheel I found another piece of hardware that prevents me from reaching the cam sensor. I'm not sure if I should use a wheel puller device to spring the metal plate loose or if it's welded on, but it is in the way of accessing the cam sensor.
Please take a look at the pictures I've attached and give me your opinion on how to get down to the sensor. That rusty plate is a nuisance preventing me from changing out the cam sensor.
Thanks!
I thought this would be an easy removal/installation, but after removing the distributor wheel I found another piece of hardware that prevents me from reaching the cam sensor. I'm not sure if I should use a wheel puller device to spring the metal plate loose or if it's welded on, but it is in the way of accessing the cam sensor.
Please take a look at the pictures I've attached and give me your opinion on how to get down to the sensor. That rusty plate is a nuisance preventing me from changing out the cam sensor.
Thanks!
#2
A new Cam Sensor arrived and it looks to be the correct component.
I thought this would be an easy removal/installation, but after removing the distributor wheel I found another piece of hardware that prevents me from reaching the cam sensor. I'm not sure if I should use a wheel puller device to spring the metal plate loose or if it's welded on, but it is in the way of accessing the cam sensor.
Please take a look at the pictures I've attached and give me your opinion on how to get down to the sensor. That rusty plate is a nuisance preventing me from changing out the cam sensor.
Thanks!
I thought this would be an easy removal/installation, but after removing the distributor wheel I found another piece of hardware that prevents me from reaching the cam sensor. I'm not sure if I should use a wheel puller device to spring the metal plate loose or if it's welded on, but it is in the way of accessing the cam sensor.
Please take a look at the pictures I've attached and give me your opinion on how to get down to the sensor. That rusty plate is a nuisance preventing me from changing out the cam sensor.
Thanks!
I've attached a few more pictures hoping that someone will recognize the problem and have a solution
#3
#4
RF Veteran
iTrader: (1)
Thread
Thread Starter
Forum
Replies
Last Post
Quasimo1
General Technical & Electrical
0
04-09-2019 06:10 PM