**HELP** Exhaust manifold stud
Thread Starter
|
Member
Joined: Dec 2010
Posts: 4
Likes: 0
From: Broookings, SD
**HELP** Exhaust manifold stud
Trying to get the heads pulled of a '97 Ranger 4.0 OHV
Drivers side rear/bottom stud/nut access is basically non-existent. I can get my fingers on it and that's about it.
EGR tube is in the way and that's rusted up so I can't remove it.
I've spent close to an hour already, other stud/nuts weren't terrible so I'm guessing this will break free fairly easy but I'm at a loss.
Thanks for any help/suggestions
Drivers side rear/bottom stud/nut access is basically non-existent. I can get my fingers on it and that's about it.
EGR tube is in the way and that's rusted up so I can't remove it.
I've spent close to an hour already, other stud/nuts weren't terrible so I'm guessing this will break free fairly easy but I'm at a loss.
Thanks for any help/suggestions
Thread
Thread Starter
Forum
Replies
Last Post
01Ext4.0
4.0L OHV & SOHC V6 Tech
5
Mar 6, 2020 01:21 PM
Hillyard
2.9L & 3.0L V6 Tech
13
Mar 11, 2010 04:11 PM
n3elz
General Technical & Electrical
26
Dec 9, 2004 04:55 PM
