94 4.0 balancer installation tool
#1
94 4.0 balancer installation tool
GREETINGS, wanted to share this. Had some SERIOUS problems finding an install tool for my harmonic balancer. Found plenty that would thread into the shaft but were too large to fit through the balancer hole. The YouTube videos I watched showed people \"tapping" the balancer with a hammer to get it started. I ordered a 12mm X 140mm 1.5 pitch bolt and nut..$5.00. I then cut off the head of the bolt, notched it to accept a large screwdriver. I used my MAP gas torch and bent a 19mm wrench..voila'.
Thread
Thread Starter
Forum
Replies
Last Post