When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am replacing my old harmonic balancer and decided to replace the seal behind it while I have the thing torn apart. I am now ready to put the new seal in but have a few questions.
1. How far in do I need to push the new seal? The old one was recessed about 1/4" - 3/8" from the front edge (basically flush with the inner edge). Do I need to recess the new one to this same location, or can I just install it flush with the front of the cover then let the harmonic balancer "push" it to its final location? I am worried about pushing it too far back into the engine.
2. The end of the cam shaft that is visible in the picture is not centered in the hole. Do I need a special tool to press the seal in, or can I just use a small ratchet extension with a mallet and slowly/gently tap it into place? I do not have a socket big enough to do the job. I am hoping I can just make it flush with the front edge then let the harmonic balancer push it the rest of the way.
01-05-2022
