When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So im doing a trans swap from a 1990 Ford Ranger A4LD because its fried...
I purchased a A4LD thats from a mustang from 1989 with 63k on the transmission however ive been reading and have ran into ONE small issue the 90 uses a 3 pin connector while the 89 uses a 2 pin..
Is this part attatched to the valve body and Will i have to swap the Bodies? Or is there another way
Dont mind the fluid in the truck i tipped it a couple of times.
