So i have a 5.0 out of a 97 explorer that i am gonna out in my 01 edge,i wanna convert to manual and i found a 91 f150 5 spd with 302 fly wheel and transfer case and hydraulic clutch transmission is a mazda built. my question is will this work out as in bolt right up or will i need to get an adapter or just a different bell housing?also looking for any thoughts on this setup

 

it should work...idk for sure though

 

so a '97 explorer 5.0 engine, and a 91F150 tranny. I'm not to sure about that, any clue the size of the engine in the f150?

 

im not sure, probably a 302 or a 300 I6

 

if its the I6 theres no way it will fit. they are two completely different engines. and i don't think the bolt pattern from the 302 and the explorer are the same either.