clunk when shifting plus vibration
#1
clunk when shifting plus vibration
ford ranger 2004 5 speed standard 4x4 . I have been putting off the mild clunking noise and I don't do allot of highway driving but Idid notice the other day when I was on the Hwy at around 110Km\h to about 125Km\h I get a vibration .
I crawled under my truck and noticed that the the rear Drive shaft coming from the transmission under the rubber boot has a little play I can move it up and down and hear a knocking noise. could this be the culprit of both the shift clunk vibration ?
I crawled under my truck and noticed that the the rear Drive shaft coming from the transmission under the rubber boot has a little play I can move it up and down and hear a knocking noise. could this be the culprit of both the shift clunk vibration ?
#2
RF Veteran
iTrader: (1)
#3
#4
RF Veteran
iTrader: (1)
Thats the slip yoke, my mistake, I though you were referring to the output shaft on transfer case
Fix for that is here: https://www.ranger-forums.com/drivet...-sticky-73528/
Fix for that is here: https://www.ranger-forums.com/drivet...-sticky-73528/
Thread
Thread Starter
Forum
Replies
Last Post
Beans
Drivetrain Tech
0
01-02-2016 09:59 PM
johnh
General Ford Ranger Discussion
0
07-15-2010 05:50 PM