transmission hole question
#1
transmission hole question
under my 2002 4x4 5 speed today
on the bottom of the tranny just off center is an open hole about 1.5" x 3.0"
looks too perfect to have been cut open, I can see the pressure plate inside
does this seem right?
I am thinking of placing a piece of sheet metal over this hole by using construction adhesive.
can someone tell me should this hole be there? how would you cover it if it need to be
doesn't make sense to me to have an opening for dirt and snow to get into
thanks
on the bottom of the tranny just off center is an open hole about 1.5" x 3.0"
looks too perfect to have been cut open, I can see the pressure plate inside
does this seem right?
I am thinking of placing a piece of sheet metal over this hole by using construction adhesive.
can someone tell me should this hole be there? how would you cover it if it need to be
doesn't make sense to me to have an opening for dirt and snow to get into
thanks
Thread
Thread Starter
Forum
Replies
Last Post
jdpartsman99
General Ford Ranger Discussion
10
01-02-2006 07:30 PM