Good morning.
I am going to be adding a snorkel as it is getting pretty deep at Corbett and Holey lands.
I am going to do the snorkel where you add a gate valve to the front of the airbox and run the pvc between inner fender and outer fender and up to cowl. From there I may add another 6" or so out of the cowl.
Anyways, I am hoping someone on here can tell me how to get the fender off the truck. I am not a body guy so I am clueless here.
Does anyone have any pics of the screws I need to take out so I know I am doing it right?
Thanks.

 

You have to remove the headlight and corner light to get to the header panel bolts(2). There is a bolt behind the bumper, infront of the tire and the plastic slash shield needs pulled loose. One inside the door(door open) up high. and one on the bottom under the plastic square box thats part of the inner fender. There are 3 small bolts to the inner fender just up under the lip and of course the ones under the hood.

 

watch out when removing the headlights.. it took me and a friend forever to figure out all you had to do was pull up the two brackets up. just make sure you dont break them. the other bolts are easy to find. just try to your fender around to find bolts you missed.