Removal and Reinstall of 2008 ranger fender flares
#1
Removal and Reinstall of 2008 ranger fender flares
Removing my flares off my 2008 ranger.. guna paint em!
whats the easiest and best way to remove them without damaging them?
Any tricks to the reinstall? wont the plastic "pins" get damaged upon removal and need new ones? 3m tape?
thanks guys!
whats the easiest and best way to remove them without damaging them?
Any tricks to the reinstall? wont the plastic "pins" get damaged upon removal and need new ones? 3m tape?
thanks guys!
#2
#3
Been a while since I had mine of but I didn't break any taking them off. Take your time and you should be fine! If I remember right I used needle nose pliers to squeeze the clips in behind the fender/bedside and pushed them through that way. The ones on the bottom of the flares I did have to replace, but those are the cheap ones. The worse ones to get out that I ran into were the bigger ones at the back of each front flare at the bottom.
#4
peice of cake, the black push pins that come up into the fender you want to cut off and replace then the main clips into the fender use a body pannel removal tool and they will pop right out.
OTC Tools Trim and Molding Removal Tools Plastic Blue Set of 5 4489 on eBay!
the second one from the left works great for fender flares.
OTC Tools Trim and Molding Removal Tools Plastic Blue Set of 5 4489 on eBay!
the second one from the left works great for fender flares.
Thread
Thread Starter
Forum
Replies
Last Post
cookiemonster
New Ideas
11
02-27-2012 06:25 PM
Want to Buy: 01-05 Fender FX 4 Fender Flares
dixie_boysles
OLD - Interior, Exterior, Electrical, & Misc.
2
11-09-2009 02:03 PM