Axle length
Thread Starter
|
Member
Joined: May 2019
Posts: 22
Likes: 0
From: Berlin wi
Axle length
I have a 1995 ford ranger 4.0 XLT super cab 4x4 and I need new ball joints upper and lower just for the passenge side but I need to know if it’s a 28 or a 32 axle anyone know what I have
Its 23 or 27 spline
Lengths are the same, 1993-2011
Dana 28 or Dana 35 hybrid axle will have 23 splines at the hub
Dana 35 axle will be 27 splines at the hub
1995-1997 Ranger can either be a Dana 35 hybrid or Dana 35
You need to look at the drive shaft side of housing, hybrid will be smoother, 35 shows more support ridges
Seen here: https://therangerstation.com/tech_li...d_example2.PNG
4.0l Ranger should have the Dana 35, but no guarantee
4x4 matters for ball joints, but I didn't think front axle type mattered?
Do yourself a favor and do both sides, and also replace u-joints on the front axles while hub is off
Lengths are the same, 1993-2011
Dana 28 or Dana 35 hybrid axle will have 23 splines at the hub
Dana 35 axle will be 27 splines at the hub
1995-1997 Ranger can either be a Dana 35 hybrid or Dana 35
You need to look at the drive shaft side of housing, hybrid will be smoother, 35 shows more support ridges
Seen here: https://therangerstation.com/tech_li...d_example2.PNG
4.0l Ranger should have the Dana 35, but no guarantee
4x4 matters for ball joints, but I didn't think front axle type mattered?
Do yourself a favor and do both sides, and also replace u-joints on the front axles while hub is off
Last edited by RonD; Jan 23, 2020 at 09:02 PM.
Thread
Thread Starter
Forum
Replies
Last Post
