Ok I think my blower motor is going out. When I have the heat to full it dosent blow out that hard. It dose get warm but wont blow it out. Where is the blower motor located at and how hard is to to change it youself? Would it be cheaper to get one from a junk yard or just get a new one?

 

does it stay like the same speed at any spot? might be the resistor known to rust out and go bad

 

yes. Lowest setting and highest setting seem to be the same. Where is the resistor loacated at??

 

It is at the right rear of the engine compartment near the blower motor.

 

its the resistor you need a good quarter inch drive socket set with extensions and a swivel to get it out there s a plug with like six wires to it and thats it

 

ya they sell the resistor and new resistor plug you cut the wires and connect the new one's they get all corroded

 

Ok I pulled the resistor today, the springs look fine not rusted or anything. The conections were rusty so I tryed to sand the rust off just to see if it would work and it didnt. Now it wont blow at all.