Ranger - Explorer Parts Compatibility
#1
Ranger - Explorer Parts Compatibility
I have a 2000 Ranger 3.0L and access to a 2000 Explorer 4.0L for parts. I was thinking of doing an engine swap seeing as how the parts are all there. I also like the white/faced dash with the tach, that my Ranger does not have. My question is, are the parts compatible/interchangable ?? I'm also likin the rims on the Expolrer.
Thanks for any input.
Thanks for any input.
#5
#6
#8
How much of a pain will it be to replace the engine and trans ? Wiring, computer, anything else. I'm assuming I will have to use "some" of the wiring harness from the 4.0L The engine has allot of miles so I will rebuild it, with a little attitude.
I read something about needing to replace the rear end of the Ranger also.
I couldn't figure out if this was the appropriate section to put the thread. My main concern is if everything will bolt on.
I sure appreciate all the input !!
I read something about needing to replace the rear end of the Ranger also.
I couldn't figure out if this was the appropriate section to put the thread. My main concern is if everything will bolt on.
I sure appreciate all the input !!
#10
Which engine do you think is in the Explorer?? It is a 2000 model. (OHV or the Complicated one LOL) I am reading about the different engines. I have access to the complete vehicle so any parts I need should be there.
#14
Thread
Thread Starter
Forum
Replies
Last Post