EGR removal
Thread Starter
|
Member
Joined: Oct 2018
Posts: 146
Likes: 8
From: Grand Island NE
EGR removal
Trying to take off the EGR valve on a 1995 Ford Ranger with the 2.3L. I can get the 1 1/16" wrench on it, but no room to move. Any other tools I can use to get better access to it?
Never had that engine but would a crowfoot wrench work?
Flare nut style is best, if it can fit over the pipe
I often need these for O2 sensors
Set here: https://www.princessauto.com/en/deta...et/A-p8259491e
But not the right sizes, you can get them as single size
Flare nut style is best, if it can fit over the pipe
I often need these for O2 sensors
Set here: https://www.princessauto.com/en/deta...et/A-p8259491e
But not the right sizes, you can get them as single size
Thread Starter
|
Member
Joined: Oct 2018
Posts: 146
Likes: 8
From: Grand Island NE
Never had that engine but would a crowfoot wrench work?
Flare nut style is best, if it can fit over the pipe
I often need these for O2 sensors
Set here: https://www.princessauto.com/en/deta...et/A-p8259491e
But not the right sizes, you can get them as single size
Flare nut style is best, if it can fit over the pipe
I often need these for O2 sensors
Set here: https://www.princessauto.com/en/deta...et/A-p8259491e
But not the right sizes, you can get them as single size
Thread
Thread Starter
Forum
Replies
Last Post
Sparky-WIshItWas
DOHC - 2.3L Duratec / Mazda L Engines
9
Oct 20, 2021 05:37 PM
Bob in Gilroy
General Ford Ranger Discussion
3
Apr 9, 2016 03:24 PM
