LED installation/turn signal issue
#1
LED installation/turn signal issue
Hey everyone,
I'm new to the ranger forums and recently after installing new LED bulbs to my 08 ranger sport 4x4, when I turn on my marker lights or all of my lights entirely both of my rear tail lights flash when I go to use my turn signal and my front turn signals work fine it's just the rear ones that flash as if I have my hazards on. I updated both the flasher relay and even the turn signal lever but still nothing and I'm wondering if there is a shortage in a wire somewhere. if anyone can help I would greatly appreciate it. thanks!
I'm new to the ranger forums and recently after installing new LED bulbs to my 08 ranger sport 4x4, when I turn on my marker lights or all of my lights entirely both of my rear tail lights flash when I go to use my turn signal and my front turn signals work fine it's just the rear ones that flash as if I have my hazards on. I updated both the flasher relay and even the turn signal lever but still nothing and I'm wondering if there is a shortage in a wire somewhere. if anyone can help I would greatly appreciate it. thanks!
#4
#5
#9
because I had a flicker issue and a canbus anti flicker device didn't do it. now my headlights are fine. as for my taillights.. only when I turn my light **** on to either my marker lights/full exterior lights for night time is when I get the duel flash in the rear when I go to use my turn signals.. the rear tail lights flash as if my hazards are on. the front turn signals are totally fine.
Thread
Thread Starter
Forum
Replies
Last Post