wheel bearings, Can you help me please?
#1
wheel bearings, Can you help me please?
Im looking for a good how to, to change my front wheel bearings. It is time for some new ones. Pictures would be great. The more visual the better. I just have never done them before and looking for help from my fellow ranger budds? Any help would be great guys. Thank you.
1996, ext cab, 4x4, 4.0 efi
1996, ext cab, 4x4, 4.0 efi
#2
pull the hubs, pull the rotors.....take a BRASS piece and use it to drive the old races out of the rotors.....there should be 2 that you can't get out, an inner and outter.....pack the new bearings properly and use the BRASS piece to drive them into the rotors......re-install the rotors and hubs....
#3
#4
#5
is this all i need? remember i have never done this before. So ill prob have dumb questions. http://www.partsamerica.com/productd...pe=184&PTSet=A
#6
Originally Posted by fletch12518
is this all i need? remember i have never done this before. So ill prob have dumb questions. http://www.partsamerica.com/productd...pe=184&PTSet=A
BUT no matter were you get them, make sure you get Timken bearings......
you need 2 inner wheel bearings and 2 outter wheel bearings, along with the spindle bearings if you plan on doing them also....
#7
Originally Posted by lifted97ranger
get the parts from a dealer........if they are reasonable with their prices.....
BUT no matter were you get them, make sure you get Timken bearings......
you need 2 inner wheel bearings and 2 outter wheel bearings, along with the spindle bearings if you plan on doing them also....
BUT no matter were you get them, make sure you get Timken bearings......
you need 2 inner wheel bearings and 2 outter wheel bearings, along with the spindle bearings if you plan on doing them also....
#10
#13
#14
Originally Posted by fletch12518
I guess when i get off i can start looking around, hopefully ford won't screw me over with prices, if they do im use to walking right out.
#15
Thread
Thread Starter
Forum
Replies
Last Post
cheese_man
Drivetrain Tech
3
01-15-2011 08:49 PM