New to me 2004 4X4 V6 Ranger Edge Sonic Blue
#76
175,000
most of that stuff is not accessible unless u raise the bed.
i DID GET THAT LED HEADLIGHT ISSUE FIXED. THEY WERE LIFETIME WARRANTY FROM HEADLIGHTEXPERTS.COM
GETTING NEW ONES AT ONLY AN UPGRADE DIFFERENCE OF $ 17 PER SIDE
UPDATE : Nov 3. Very poor communication & service from Headlightexperts.com. Had my bank reverse the payment, and simutaneously e mailed them to cancel.
Got what i needed here in town at Autozone.
most of that stuff is not accessible unless u raise the bed.
i DID GET THAT LED HEADLIGHT ISSUE FIXED. THEY WERE LIFETIME WARRANTY FROM HEADLIGHTEXPERTS.COM
GETTING NEW ONES AT ONLY AN UPGRADE DIFFERENCE OF $ 17 PER SIDE
UPDATE : Nov 3. Very poor communication & service from Headlightexperts.com. Had my bank reverse the payment, and simutaneously e mailed them to cancel.
Got what i needed here in town at Autozone.
Last edited by EF Hutton; 11-03-2022 at 08:47 AM.
#77
#80
#81
I removed the old EGR valve and it could see it was pretty dirty inside. I bought and installed a new one from NAPA this morning as they actually had one in stock. It took approx 15 min to remove the old and install the new taking my time. This video made it pretty simple.
Since I cleaned the MAF and replaced the EGR I hear a really noticeable difference in the engine as it now idles/purrs perfectly.
https://www.1aauto.com/how-to-replac...er/video/47354
2004 Ranger V6 4.0 EGR valve
Since I cleaned the MAF and replaced the EGR I hear a really noticeable difference in the engine as it now idles/purrs perfectly.
https://www.1aauto.com/how-to-replac...er/video/47354
2004 Ranger V6 4.0 EGR valve
Last edited by Patriot1; 11-09-2022 at 03:21 PM.
#82
Well the topper is in the paint shop getting prepped and primed for a fresh coat of Sonic Blue met. I will post up photos some time next week after it gets reinstalled.
For now she’s topless with new Edge decals.
I am having this higher quality rubber seal installed between the topper and bed rail. It makes for a water tight seal. The foam tape used by most topper installers is worthless. It flattens out after a few months. This works great on my F350 ARE topper so the Leer topper will get it as well.
For now she’s topless with new Edge decals.
I am having this higher quality rubber seal installed between the topper and bed rail. It makes for a water tight seal. The foam tape used by most topper installers is worthless. It flattens out after a few months. This works great on my F350 ARE topper so the Leer topper will get it as well.
Last edited by Patriot1; 11-11-2022 at 07:40 PM.
#83
The following 2 users liked this post by Patriot1:
Fordzilla80 (11-23-2022),
RoseBud68 (11-23-2022)
#85
#87
The following users liked this post:
Fordzilla80 (11-29-2022)
Thread
Thread Starter
Forum
Replies
Last Post
wydopnthrtl
OLD - Ranger Based Vehicles
2
04-12-2009 05:47 AM