okay well i have been hearing a lot of squeeking in my driver side front wheel then my abs light came on so i decided to check it out well i take off the wheel everything looks fine then i ttake the calipor off the pads are fine so i go to take off my Rotor and its not even on its all over the place so i take of the locknuts and stuff and my abs sensor is grinded off i think im missing something behind my rotor is there like a bearing or something that goes there? MY wheel when i put it back on also goes all over the place it doesnt look healthy ha

 

wow... ever heard of punctuation? comma's, colons, semi colons, periods, question marks??
My eyes are still bleeding from reading your attrocious thread.

 

yeah i have but this isnt english class so f it

 

Are you 2wd or 4wd...

Did you do your brakes your self?

Sounds like if your 2wd your missing your inner bearing or its bad... or your inner seal came out... and since its so loose your ABS exciter ring got messed up..

rocky

 

New rotor, Inner and Outer bearing, inner seal, and you should be good to go...

If your 2wd...

 

im 4wd

 

and yeah i can take pictures

 

And a new ABS sensor

 

edited

 

 

 

oh boy thats gonna be all kinda fun to rebuild...

just the Seals and the bearings alone for both sides is $400+

i bet that needle bearing in the spindle where the axle goes is toast prob too. wonder how all those u-joints look also..

 

well its only this side the other side is fine how do i no if the u joints are bad

 

anyone know anything else that could be wrong? how much do you think it would cost to repair?

 

I have to agree. Not bashing you man, but seriously. That was EXTREMELY hard to read.

But with that being said.........Wow, not that's some serious grenade action there. Damn........