1998 Cab Swap to 2000 frame
#1
11-26-2018
Join Date: Nov 2018
Location: Cameron WV
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
1998 Cab Swap to 2000 frame
Ok, so this is just a beater truck I have just to hone on all the time. It is a 2.5L 4cyl, 5 speed, 2wd. So i have a 1998 cab that I put on a 2000's frame. I have power to the radio, battery gauge and oil gauge. However I have no power to the engine. I have a feeling I need to swap the computers. I know where they are but how to I switch them? Please LMK what I should do. I am 15 and I built this truck over the summer because we got another ranger to replace. However I wanted to have a beater.
#2
11-26-2018
Welcome to the forum
Yes, the computer needs to stay with the engine
The computer is in the firewall of the 2000 cab and can be removed and put in the 1998 cab
Picture of computer with its connector removed here: https://www.explorerforum.com/forums...cm2-jpg.59583/
After connector is off remove the two outter nuts and remove computer
Yes, the computer needs to stay with the engine
The computer is in the firewall of the 2000 cab and can be removed and put in the 1998 cab
Picture of computer with its connector removed here: https://www.explorerforum.com/forums...cm2-jpg.59583/
After connector is off remove the two outter nuts and remove computer
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: single cab needed in (east tn)
gold$bazooka
OLD - Interior, Exterior, Electrical, & Misc.
1
03-13-2011 04:53 PM
