88 2.3L - Wiring problems - No power at coil
Thread Starter
|
Member
Joined: May 2013
Posts: 3
Likes: 0
From: cary, nc
88 2.3L - Wiring problems - No power at coil
I completely swapped this motor from an 88 Ranger along with the harness and the ECU/ECM and I'm trying to make it run independently of trans/fuel pump
I am having some problems getting it wired correctly.
Pin 1 (KAPWR - Keep alive Power) runs down to the positive Battery Terminal
The 3 Green/Black ground wires next to the KAPWR strap are bolted to the chassis.
I've jumpered the EEC Power relay to Power pins 37 & 57 so the system should have power.
When I turn the engine over I have no spark, because there is no power to the coil...
What am I missing?
I am having some problems getting it wired correctly.
Pin 1 (KAPWR - Keep alive Power) runs down to the positive Battery Terminal
The 3 Green/Black ground wires next to the KAPWR strap are bolted to the chassis.
I've jumpered the EEC Power relay to Power pins 37 & 57 so the system should have power.
When I turn the engine over I have no spark, because there is no power to the coil...
What am I missing?
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: Coil spring lift, coil spacers - AL
ubwfuf
OLD - Suspension, Tires, & Wheels
9
Mar 10, 2011 11:27 AM
aeidian
General Technical & Electrical
2
Sep 21, 2010 05:15 PM
pushdeck
Suspension Tech
7
Jun 15, 2006 08:33 AM
