AC clutch relay jump to force clutch
#1
#2
RF Veteran
iTrader: (1)
On the top of the compressor there is a two wire connector, this gives 12volts and a ground to the Clutches Coil which will engage the clutch.
There is no + and - it is a coil of wire inside, so 12v on one tab and ground on the other.
Compressor should start on it's own if there is pressure in the system, no need to "draw in freon", could burn out the compressor that way.
There is no + and - it is a coil of wire inside, so 12v on one tab and ground on the other.
Compressor should start on it's own if there is pressure in the system, no need to "draw in freon", could burn out the compressor that way.
Thread
Thread Starter
Forum
Replies
Last Post
cheese_man
General Technical & Electrical
1
07-18-2014 03:25 AM
2004xlmiller
Interior Semi-Tech
10
12-14-2011 05:43 PM