Alarm Problem 2003 3.0
Thread Starter
|
Member
Joined: Dec 2015
Posts: 305
Likes: 6
From: los alamos ca
Alarm Problem 2003 3.0
Hi all
I got myself a 2003 ranger 3.0 2wd....had trans problem bought as is...fixed trans and i noticed the horn connection was pulled off....PO said last owner pulled wire....So i fitted wire connector to horn, horn works ok on steering wheel, power doors locks work ok .
During the day today the horn alarm beeped 5 times.....evening did the same thing...What do i need to fix...is there a module under dash
I got myself a 2003 ranger 3.0 2wd....had trans problem bought as is...fixed trans and i noticed the horn connection was pulled off....PO said last owner pulled wire....So i fitted wire connector to horn, horn works ok on steering wheel, power doors locks work ok .
During the day today the horn alarm beeped 5 times.....evening did the same thing...What do i need to fix...is there a module under dash
2003 Ranger will have a PATS(passive anti-theft system) that will prevent starter motor and fuel system from working if the key used to start it isn't "recognized".
This system is as it says "passive" no horn or lights, just won't start.
Dealer, or past owner, has installed a perimeter alarm system, i.e. if something or someone bumps the truck or tries to break in the horn will sound and lights may flash.
Dealer installed are "factory alarms" but not installed at the factory, lol.
And these alarms usually only trigger if door is opened without unlocking it first, no motion detector.
3rd party usually include motion detection.
Can you turn the alarm on and off?
i.e. rolled down window, get out and lock doors with key fob
reach in and open door using inside handle and see if alarm activates
If not then you don't have an alarm and probably have a wiring/relay issue, horn circuit has power all the time, not sure if it is on the Battery Saver circuit or not.
Battery Saver cuts power to most fuses after truck is off for 20-30 minutes
Also does the horn work when you use steering wheel button?
On 2003 I think the horn relay is in "aux relay box 1" just above gas pedal towards center console, box has a removable black lid.
Google: ford ranger auxiliary relay box 1
This system is as it says "passive" no horn or lights, just won't start.
Dealer, or past owner, has installed a perimeter alarm system, i.e. if something or someone bumps the truck or tries to break in the horn will sound and lights may flash.
Dealer installed are "factory alarms" but not installed at the factory, lol.
And these alarms usually only trigger if door is opened without unlocking it first, no motion detector.
3rd party usually include motion detection.
Can you turn the alarm on and off?
i.e. rolled down window, get out and lock doors with key fob
reach in and open door using inside handle and see if alarm activates
If not then you don't have an alarm and probably have a wiring/relay issue, horn circuit has power all the time, not sure if it is on the Battery Saver circuit or not.
Battery Saver cuts power to most fuses after truck is off for 20-30 minutes
Also does the horn work when you use steering wheel button?
On 2003 I think the horn relay is in "aux relay box 1" just above gas pedal towards center console, box has a removable black lid.
Google: ford ranger auxiliary relay box 1
Last edited by RonD; Jan 10, 2016 at 07:13 PM.
Thread Starter
|
Member
Joined: Dec 2015
Posts: 305
Likes: 6
From: los alamos ca
The horn does work from the steering wheel button, rolling down a window and locking doors does not sound an alarm when reaching in and opening the door....locking all doors with the key fob the horn honks once...so i only have the PATS system right.....when the wires were off the horns i did do a test light into the connectors and did hear the relay click
Thread
Thread Starter
Forum
Replies
Last Post
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
0
Jul 22, 2010 03:23 PM
Strider0O0
General Technical & Electrical
7
Aug 10, 2004 10:52 AM
