After doing the body change on my 99 with a 98 4wd frame. Changing the engine compartment harness(3.0 to 4.0), the dash harness(2wd to 4wd), the transfer case harness, and the engine harness(standard to automatic). I finnally have enough of it together to finally start er up. Of course I put the battery in, no smoke...so far so good. Turn the key and bump the starter...she turns. Try the remote from the parts truck...it works. Figure we are ready to go...wrong, no fuel pump. First thought the inertia switch. Pull out the haynes manual to see a switch with 2 wires, green and pink. Look at my switch and find 3 wires, the only hot one is the brown one? Of course you can't expect much from a haynes manual. I guess the number of the fuse or relay would have been nice but I guess they think you don't need that information. Fortunatly I have an extra harness complete with relays so I just swapped them all. Still no fuel pump. Of course the pump could be bad (it was in a wrecked truck)but I have no power. Anybody have any suggestions? For all purposes this truck is now a 98 (frame, wiring, security, engine)with a 99 title and body.

 

Bump ...
Can anybody upload me a wiring diagram or tell me the relay and fuse numbers? Any help is appreciated. What else can cause the pump to not have power?
John