HVAC Knob Question
#1
#2
I actually jus did this 20 mins ago. Hold the **** in ur hand and you need to use a screw driver or a key as i did and press down on the little recessed white piece. Once it pops out take wet sand paper and sand off the white top that has the green underneath it. i then covered the small plastic piece with red vinyl but if your modding the unit to leds you could keep the switch with a clear piece and whatever light you choice will shine through. Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
lougotzz
General Ford Ranger Discussion
13
01-05-2009 08:21 PM