General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

speedo, odo, and wipers not working!

Thread Tools
 
Search this Thread
 
Old May 3, 2021
  #1  
zwancat's Avatar
Thread Starter
|
Member
Joined: May 2021
Posts: 6
Likes: 2
From: Huntsville
speedo, odo, and wipers not working!

i recently replaced all of the bulbs in the inst cluster and now my speedo, odo, and wipers are unresponsive. tried fuses, checked wiring and bulb connections and nothing has helped need ideas.
truck is 2000 xlt with the 2.5l and manual trans
 
Reply
Old May 3, 2021
  #2  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,952
From: Vancouver, BC
Welcome to the forum

Speedo/odo use the same signal, a wire from GEM Module, wipers also use GEM module

GEM is behind the radio

Check fuses 10, 20 and 25 in cab fuse box, all 7.5amp they power up the GEM

Fuse 16 powers the wipers but no connection to speedo/odo

With fuses you HAVE TO pull them out and have a look but way way better to test them with OHM Meter



 
Reply
Old May 3, 2021
  #3  
zwancat's Avatar
Thread Starter
|
Member
Joined: May 2021
Posts: 6
Likes: 2
From: Huntsville
checked all fuses looked good. truck is now throwing code p0500 and p1506
 
Reply
Old May 3, 2021
  #4  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,952
From: Vancouver, BC
P0500 is because of no speed signal, from GEM

Is the ABS light on?
If not then problem is at the GEM or wiring from it

ABS uses same speed sensor as GEM in a 2000 Ranger, if ABS light was also on the could be speed sensor issue but no ABS light means thats not the issue

GEM is just to the right of the cluster, but behind the radio, did you pull on any wire coming from the right?

GEM also has 2 ground points/wires on the firewall

Does the dome light work, does it come on when door is open?
And does the door AJAR light come on?
Both are also operated by the GEM

 
Reply
Old May 3, 2021
  #5  
zwancat's Avatar
Thread Starter
|
Member
Joined: May 2021
Posts: 6
Likes: 2
From: Huntsville
no abs or door ajar light dome light was ripped out by previous owner because door sesors thought door was always open i fixed it easily. i did disconnect all three plugs on back of cluster but i made sure they where all plugged in correctly with dielectric grease because that was my first thought.
made sure to only pull on the connector in case of messing up any wires
 
Reply
Old May 3, 2021
  #6  
zwancat's Avatar
Thread Starter
|
Member
Joined: May 2021
Posts: 6
Likes: 2
From: Huntsville
update found fuse 26 is blown
 
Reply
Old May 3, 2021
  #7  
zwancat's Avatar
Thread Starter
|
Member
Joined: May 2021
Posts: 6
Likes: 2
From: Huntsville
replaced fuse problem solved thanks for all your help
 
Reply
Old May 3, 2021
  #8  
2011Supercab's Avatar
Member
Joined: Jun 2018
Posts: 2,365
Likes: 393
From: Everett, WA
Originally Posted by zwancat
checked all fuses looked good. truck is now throwing code p0500 and p1506
Originally Posted by zwancat
update found fuse 26 is blown
That's why it's best to replace or check with a continuity tester any suspect fuse.
 
Reply
Old May 3, 2021
  #9  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,952
From: Vancouver, BC
Good stuff
 
Reply
Old May 3, 2021
  #10  
zwancat's Avatar
Thread Starter
|
Member
Joined: May 2021
Posts: 6
Likes: 2
From: Huntsville
diagram i had listed 26 as unrelated so i didnt check it until i saw a similar post with it as the culprit so i checked it. lo and behold the culprit was found.
 
Reply
Old May 3, 2021
  #11  
2011Supercab's Avatar
Member
Joined: Jun 2018
Posts: 2,365
Likes: 393
From: Everett, WA
2000 Ranger fuse 26 10 amp = At least according to the owners manual, controls these.

Battery Saver Relay,
Electronic Shift Relay,
Interior Lamp Relay,
Power Window Relay,
Electronic Shift Control Module,
Dome/Map Lamp,
GEM,
Instrument Cluster
 
Reply
Old Jun 28, 2021
  #12  
alexanderadam's Avatar
Member
Joined: Jun 2021
Posts: 2
Likes: 0
From: istanbul
No abs or door ajar light dome light changed into ripped out through previous proprietor due to the fact door sesors idea jiofi.local.html door was always open i fixed it without difficulty.Showbox I did disconnect all three plugs on lower back of cluster however i made sure they in which all plugged in successfully with dielectric tplinklogin grease because that changed into my first thought.
Made certain to most effective pull on the connector in case of messing up any wires
 

Last edited by alexanderadam; Jun 29, 2021 at 01:24 AM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
flyingduck
General Technical & Electrical
22
Aug 30, 2020 02:56 PM
iponnet22
General Technical & Electrical
7
Nov 23, 2012 01:51 PM
95Rangerjunkie
SOHC - 2.3L & 2.5L Lima Engines
5
Mar 26, 2012 03:31 PM
Rangerboy69
4.0L OHV & SOHC V6 Tech
3
Oct 13, 2010 09:44 PM
littlered
General Technical & Electrical
29
Sep 8, 2009 10:03 PM




All times are GMT -6. The time now is 01:07 AM.