Afew questions
#1
Afew questions
I have a 2000 ranger that I swaped in a 5.0 from a 99 explorer and was wondering which wiring harness to use the 3.0 or the 5.0 harness. I am also doing a sas and am curious about the speedo. The singnal I believe comes from the rear axel but I am using a dana 60 rear and pretty sure that I am going to use the same in the front. Where should I get the signal for the speedo so I know how fast I am going or can I use a newer one from a f250 or 350 that has the toner ring on the front axel and use that signal. Unsure about this but thanks for the response that you give.......
#4
"signal for the speedo comes off your transmission."
Not on a stock 2000, it doesn't.
VSS on the rear axle is the speed signal source, then it gets "conditioned" by the 4WABS module.
Jay, I can send you VSS/ABS Wiring Diagrams for a 2000, if you PM me an e-maill address that will receive .pdf attachments. I'll send you what I sent Tim, it's already handy.
Not on a stock 2000, it doesn't.
VSS on the rear axle is the speed signal source, then it gets "conditioned" by the 4WABS module.
Jay, I can send you VSS/ABS Wiring Diagrams for a 2000, if you PM me an e-maill address that will receive .pdf attachments. I'll send you what I sent Tim, it's already handy.
Thread
Thread Starter
Forum
Replies
Last Post
MyYellowRanger
Interior Semi-Tech
11
06-15-2004 01:51 PM