Ok so today I realized how much I don't like not haveing councel. So I want to put bucket seats in my '87. So do u guys kno where I could get some bolt on bucket searlt or do I have to get like escape seats and make my own brackets to make it fit.

 

i put a passenger seat in my drivers seat rails. i did this with both rangers i had. you could go for explorer seats or something. the only thing with my setup is that the lever to tilt the seat forward is in the middle of the truck but i can put stuff be hind the seat so theres no need to tilt it anyways. good luck

 

oh do you have a bench or a 60/40. if its a bench my nonsense wont help you at all.

 

Seats from a bronco II or first gen explorer will work you just need 60/40 or bucket seat seat rails . if you have bench in the truck now you will most likly have to drill holes for the inner tracks

 

no right now i got a full bench.do u kno how much it will be for a 1st gen explorer seat or bronco seat will be?

 

PM 93mk8, he may want to trade your bench for his 60/40 which you could easily mod into buckets

 

my bucket seats cost me 20 bucks for near new condition

 

you should still have holes in the floor for the 60/40 seats to bolt to. if you do then you just need the tracks off some of them and a set of bucket seats.

 

Ok I will pm 93mk8. Does he lve in mchigan. The driver side seat rail is rusted so I got to take the seat out so I can move it a bit back cuz I'm 6'2 and is kinda tight in the leg and also from the wheel to my stomach. So I figured since I got it out I mine as well put in buckets. The seat cover is in 9/10 condition. There is just a little rip on the top my the back window and that's the only bad thng about the cover