hey all scored some expo eddie bauer seats yesterday! got the front bolt hole larger but my question is on the seat belts. the seat belts connector that come with the seats doesnt fit my belts now, but the connector that i have from my seats wont mount where the seat belt connector is now cuz its a dif shape. when photobucket comes back up i will get pics up.

 

nm the seatbelt question. just need to bend the tabs down where the connector mounts at and it fits fine. what wire is power on 96 eddie bauer expo seats?

 

nm to that too, figured out black is ground and black/white is power. seats are nice.

 

you put them in a reg cab?

 

no in a ext cab 2 dr. sorry my pic isnt up to date that was my last truck.

 

i got ya. i was going to say, if you got them in a reg cab that easy, i want to know your secret!

 

I should come here more often, first off I apoligize for jacking your thread, but I spent the whole day today putting in a set of expo seats. Had to move some stuff around to get them in had an amp under the drivers seat now it sits under my sub box.
Used the seat belts from the ranger and tapped out the rear most hole in the expo seat to 10mmx1.25 thread and drilled and slotted for the tang on the srs tensioner so I could use the rangers wiring.
Ran power to the seats from my distribution block for my amps to power them up.
Fused them with a 20 amp fuse for both.
I wish I knew what year they are out of the driverside lumbar switch doesn't hold air so I am going to need a new one, Anyone know if the switches are different I am pretty sure they are from a early 2000-2004 vintage expo.
Seats are nice now all I need is a console. Attached are a couple pics.

 

turbo, pm'd you...

 

Got it pm'd ya back!