Tinting Question
#1
Tinting Question
I am wanting to tint my driver and passenger windows. I have tried before and it is a pain. Is the easiest way to just remove the glass and do it that way. I know it is pretty simple to get the glass out and then replace the rivet with a bolt. Has anyone done this and if so can you give me some feedback on it. Thanks
#2
With the panels off, you can pull the glass as you mention....
BUT
If you've got the interior panel off you can work the tint easily (just precut the film) roll the window down a bit to get the top edge and clear any of the water (I usually get it all clear for a few inches down, so you can roll the window back up into the felt door seals)....
The bottom is a cinch wih the interior panel off...
If you skip pulling the panel and book-fold your film as you install, you can work the top (as above) and if you get the glass/film wet enough (small, fine spray) sliding the lower edge under the bottom felt is easy enough using a bondo-spatula or similar to get you alittle room ... Just sayin.
BUT
If you've got the interior panel off you can work the tint easily (just precut the film) roll the window down a bit to get the top edge and clear any of the water (I usually get it all clear for a few inches down, so you can roll the window back up into the felt door seals)....
The bottom is a cinch wih the interior panel off...
If you skip pulling the panel and book-fold your film as you install, you can work the top (as above) and if you get the glass/film wet enough (small, fine spray) sliding the lower edge under the bottom felt is easy enough using a bondo-spatula or similar to get you alittle room ... Just sayin.
Thread
Thread Starter
Forum
Replies
Last Post
(907)FAN-BOY
General Ford Ranger Discussion
14
02-13-2006 06:01 PM