im looking for a bed mounted roll bar for my 2002 ranger edge stepside. i have a found some for the regular bed bt not flareside. my bed is 49" please help

 

If ya can't find one have one built!
http://autoweldchassis.com/rbc.ivnu

http://www.truckrollbar.com/3barphotos/index9.html

 

Show bar or legit rollbar?
I can't remember how i came by mine, but its called a Bigfoot showbar. i think. originally it was a double front bar. but i didn't like that, so i made it single. however. mine is the ONLY one i've ever seen with a bent bar going to the bed, i've always seen them strait.

Its in the winter, but its the best picture i have to show the bar.

 

Show bar is all im lookin for the flareside is really making it much harder because the bed is only 49" im ab to look in to getting 1 built thanks for the help!!

 

^^^ nice rollbar Alex

 

the front bar will have to be bent inwards at the bottom where it meets the bed, mines something like 10 degrees. since your bed is going to be a bit smaller, it'll be a more sharper angle, but you can always bend it a bit more once its in the bed, mine used to touch both sides of the bed and you couldn't even get some paper in there. after i sercured one side about a 1/16th away from the bedside, i just pulled the other untill it bent enough.


Thanks. It used to be chrome. thats a whole story in itself on how i got rid of that.

 

I bought a roll bar for a regular bed for about $40. I had to cut it to make it fit. But I'd recommend buying one off craigslist or ebay rather than buying an expensive brand new one.