after market temp guage
Oil, trans or coolant temp?
For coolant then heater hose would probably be the best bet.
Look here: Accessories - Adapters, Fitting & Hose
You will see the adapters at the top but then scroll down to row 7 and you will see the heater hose bungs, you cut the hose nearest the thermostat housing and insert it there, then install the 3rd part temp sender for the 3rd party gauge.
You may need one of the adapters at the top of the page.
Some senders need to be grounded, the bung should have a ground screw, smaller threaded hole, so use a jumper wire from there to engine bolt or ??, a good ground.
The ones pictured in above link come with the grounding stuff.
For coolant then heater hose would probably be the best bet.
Look here: Accessories - Adapters, Fitting & Hose
You will see the adapters at the top but then scroll down to row 7 and you will see the heater hose bungs, you cut the hose nearest the thermostat housing and insert it there, then install the 3rd part temp sender for the 3rd party gauge.
You may need one of the adapters at the top of the page.
Some senders need to be grounded, the bung should have a ground screw, smaller threaded hole, so use a jumper wire from there to engine bolt or ??, a good ground.
The ones pictured in above link come with the grounding stuff.
Thread Starter
|
Member
Joined: Mar 2016
Posts: 14
Likes: 0
From: dyersburg,tn
temp guage
Oil, trans or coolant temp?
For coolant then heater hose would probably be the best bet.
Look here: Accessories - Adapters, Fitting & Hose
You will see the adapters at the top but then scroll down to row 7 and you will see the heater hose bungs, you cut the hose nearest the thermostat housing and insert it there, then install the 3rd part temp sender for the 3rd party gauge.
You may need one of the adapters at the top of the page.
Some senders need to be grounded, the bung should have a ground screw, smaller threaded hole, so use a jumper wire from there to engine bolt or ??, a good ground.
The ones pictured in above link come with the grounding stuff.
For coolant then heater hose would probably be the best bet.
Look here: Accessories - Adapters, Fitting & Hose
You will see the adapters at the top but then scroll down to row 7 and you will see the heater hose bungs, you cut the hose nearest the thermostat housing and insert it there, then install the 3rd part temp sender for the 3rd party gauge.
You may need one of the adapters at the top of the page.
Some senders need to be grounded, the bung should have a ground screw, smaller threaded hole, so use a jumper wire from there to engine bolt or ??, a good ground.
The ones pictured in above link come with the grounding stuff.
Thread
Thread Starter
Forum
Replies
Last Post
jdcrush
General Technical & Electrical
4
May 18, 2008 10:07 PM
