I have a few new pic from over christmas break.
first is the front hitch i built and put on sometime last fall.




This is just when i got home there were some drifts back in our pasture that I deceided to go through


Cut a few loads of wood while I was off. these two loads was about all it could hold.




And then i finally got my brush guard back on after the body lift. had weld on some material and drill new mounting holes. it isnt quite level and it rubs on the bumper pads. I will fix that and get it painted when it warms back up.


pic of it rubbing. the bottom bar is also going to be cut off becuase its already bent and it is in the way of my hitch and D ring.

 

i would keep the bottom bar, it gives the brush guard a lot more strength than it would be without.

 

Why put the brush guard on if it blocks your front hitch?

 

I didnt know it was going to block it before i put it on and i think if it take the ring off and put it back over the top of the bar it will be fine for now. Im going to make a front skid plate that bolts to the bottom of the brushguard and i might add a new bar that is above the hitch.