i put the c/o in the top mount and then put in the bottom let it settle a bit and then put a couple tacks along the side of the upper mount and then pulled the c/o out and drilled and bolted...sound like the right process? And can somebody put up a picture of what its supposed to look like from above like upper ball joint view of the cv and how close it is to the c.o

 

Im Donnnne!

 

NICE! Pics please!

 

ill take them today when i get back from getting an alignment

 

whenever i hit a bump while turning right i get a popping noise from left front..any ideas?

 

wheel bearing...cv i think..

jack up the front left see if you can rock the tire back and forth..

see if your cv is loose or something if not ripped

make sure your caliper is on there tight..

 

its a brand new wheel bearing..put it in when i was reassembling and the cv possibly..the boot on it is torn..and caliper is on there nice and tight.my dad said it could be the ball joints too?

 

get an alignment yet? If not do it and have your ball joints checked as well as your tierods. One of my tierods was done and my lower BJs were going.

 

Sounds like balljoint and now that you have the lift on, the already bad balljoint has so much more stress on it. When I did my RCD I replaced upper and lower bjs just because I didnt feel like taking it apart again for a long time.