fabtech spindle to heim joint conversion
#1
fabtech spindle to heim joint conversion
I have a 97 explore w/ 3 inch fabtech spindle and want to build my own upper control arm w/ a mono ball. But here is my question does any one make a mono ball cup w/ a ball joint pin so I can still put the clench bolt back on to hold the cup???????
#2
I was going to tap my spindle, then use a grade 8 bolt. Once the bolt was all the way in i was going to mark where the pinch bolt goes and notch the bolt. I know someone was looking into making a pin for that...I will see if anything came of it for you.
#3
#4
....which is why i didnt go that route. I have heard from some it is ok to tap and other say it is a no no.
Thread
Thread Starter
Forum
Replies
Last Post
darangerdanger
Suspension Tech
3
11-05-2010 09:09 AM
zabeard
Suspension Tech
20
04-11-2007 08:36 AM