obd port flakey?
#1
obd port flakey?
so for about a year and a half I've had my scangauge plugged into the OBD port. Recently it has started going blank, like no power from the port, or engine has been turned of, while driving. It's completely random and sporattic, it can go days without happening, or several times in a day.
If I unplug the wire from the scangauge and plug right back it, it's turns back on.
I've had the SG updated, and ran it for a month in my escape without any issues. But back in the ranger it randomly turns off.
Could there be a fuse, or loose wire somewhere? Maybe the signal it uses to stay on is not getting to the port. (I can't recall if it's rpm or something else)
Any thoughts?
If I unplug the wire from the scangauge and plug right back it, it's turns back on.
I've had the SG updated, and ran it for a month in my escape without any issues. But back in the ranger it randomly turns off.
Could there be a fuse, or loose wire somewhere? Maybe the signal it uses to stay on is not getting to the port. (I can't recall if it's rpm or something else)
Any thoughts?
#2
Thread
Thread Starter
Forum
Replies
Last Post
FRXLT
General Technical & Electrical
14
05-25-2009 07:48 PM
Scallion02EDGE
4.0L OHV & SOHC V6 Tech
4
08-14-2006 07:27 AM
n3elz
General Technical & Electrical
7
01-21-2005 11:10 AM
n3elz
General Technical & Electrical
3
10-22-2004 06:06 PM