Any Idea What This Is?
#1
#3
Had some slightly larger hose lying around so I cut out the melted section and fed the two pieces into both ends of the new section. Also ran it through one of the holes on the frame rather than around it next to the exhaust. The truck runs better now as well. It would try to die if I didn't rev it way up when starting from a stop or at low rpm's and low speeds.
Thread
Thread Starter
Forum
Replies
Last Post
nross
Drivetrain Tech
8
05-01-2009 08:19 PM
MikeyFord3
General Technical & Electrical
5
09-12-2008 11:39 AM
FMD
General Ford Ranger Discussion
1
11-11-2007 01:21 PM