Hey guys, I got a quick question I have a 2004 ford ranger xlt with a 3.0l engine, now my engine is toasted previous owners used water on cooling system and rotten everything inside to the point of headgasket failure, now I found a 3.0l engine from a ford ranger 2000 will it plug and play on my ranger? Engine is from 2000 and my chassis and computer is from 2004.

 

Welcome to the forum

No, probably not plug and play, but maybe

The engine itself is fine to use
And exhaust is the same
Along with all the accessories, i.e. alternator, power steering, ect.............

But upper and lower intakes "may not" be plug and play as Ford changes connectors with no specifics by year
So 2000 fuel injector plug-in may or may not match 2004 wiring connector???
Just have a look as you go

 

The lower and upper intake I use my own from my engine, I was just mainly concern about wiring.

 

Then you will be fine
3.0l Vulcan engine was basically the same from 1986 thru 2008, a few updates of course, but bolt on parts are transferable between years

3.0l Vulcan guide here: https://www.therangerstation.com/tech/ford-3-0l-build/

The front cover, timing chain cover, has 2 coolant passages for the water pump, these are known leak points, good to change that gasket and front seal, timing chain is fine, never an issue with this engine
Rear main seal is good to change on any engine when its out

 

Hey Ron quick question the engine would only gives half a turn with some force we manage to make a full turn, is this engine good? Any thing to worry about the valves?
thats the video how the engine is

 

No, doesn't look good assuming the spark plugs were out