Thermostat Housing Unit
#1
#2
RF Veteran
iTrader: (1)
Reverse Drill bit and "easy out" would be what to use, but if the bolts are stripped the holes may be damaged as well.
I believe 1993 3.0l will have an aluminum intake, you would need to re-tap the holes and possibly redrill for larger bolts.
OR
Call local wrecking yards and get price on Lower Intake manifold, the 3.0l Vulcan engine was used in many Ford models, and the Lower intake should be the same on most, but wrecking yard will have that info.
Also gasket set for lower/upper intake cost
Weigh the options/costs and get what you think is best
I believe 1993 3.0l will have an aluminum intake, you would need to re-tap the holes and possibly redrill for larger bolts.
OR
Call local wrecking yards and get price on Lower Intake manifold, the 3.0l Vulcan engine was used in many Ford models, and the Lower intake should be the same on most, but wrecking yard will have that info.
Also gasket set for lower/upper intake cost
Weigh the options/costs and get what you think is best
Last edited by RonD; 10-18-2015 at 01:37 PM.
Thread
Thread Starter
Forum
Replies
Last Post