'94 Mazda 4.0L cam position sensor
Thread Starter
|
Member
Joined: Mar 2010
Posts: 25
Likes: 0
From: Roy, Utah
'94 Mazda 4.0L cam position sensor
I cannot get to the bolt on my cam position sensor at the back of the engine just behind the intake manifold. I believe the size of the head is 10mm. Is this correct?
An open end wrench doesn't have space enough to move after contacting the head. It's all feel, so I don't really know if I'm getting the wrench on the head.
A box end wrench won't go on it because the sensor overhangs the bolt and it is too low to allow a regular box end wrench in there. Before I grind the box end thinner I want to be sure of the size and that I'm on the right track.
Is there a newly engineered wrench which will work under these conditions? Any help will be appreciated. Thanks, IslandFord
An open end wrench doesn't have space enough to move after contacting the head. It's all feel, so I don't really know if I'm getting the wrench on the head.
A box end wrench won't go on it because the sensor overhangs the bolt and it is too low to allow a regular box end wrench in there. Before I grind the box end thinner I want to be sure of the size and that I'm on the right track.
Is there a newly engineered wrench which will work under these conditions? Any help will be appreciated. Thanks, IslandFord
Thread
Thread Starter
Forum
Replies
Last Post
