Automatic to manual trans swap,02 model. 3.0 litre engine
#1
Automatic to manual trans swap,02 model. 3.0 litre engine
I have already swapped all over to the manual. I have not changed computer and wiring. Truck starts runs accelerates smoothly, however it will not climb above 3000 rpms,on the engine. How can I trick the computer to believe the automatic is still there? To bypass the Rev limiter?
#3
RF Veteran
iTrader: (1)
How did you get the starter motor to work?
Signal for that goes thru the DTR(digital transmission range) sensor, so you must have by passed it?
You need to do the same by pass on the DTR, so computer "thinks" transmission is in D-Drive.
There is no way to simulate automatic trans, so CEL(check engine light) will stay on all the time.
You can send the Computer out to a programmer and they can remove the auto software from it, also give it a better tune for manual trans use
Are you reading your OTHER POSTS????
Like here: https://www.ranger-forums.com/member...-model-154165/
Where I answered it the first time you asked
Signal for that goes thru the DTR(digital transmission range) sensor, so you must have by passed it?
You need to do the same by pass on the DTR, so computer "thinks" transmission is in D-Drive.
There is no way to simulate automatic trans, so CEL(check engine light) will stay on all the time.
You can send the Computer out to a programmer and they can remove the auto software from it, also give it a better tune for manual trans use
Are you reading your OTHER POSTS????
Like here: https://www.ranger-forums.com/member...-model-154165/
Where I answered it the first time you asked
#5
How did you get the starter motor to work?
Signal for that goes thru the DTR(digital transmission range) sensor, so you must have by passed it?
You need to do the same by pass on the DTR, so computer "thinks" transmission is in D-Drive.
There is no way to simulate automatic trans, so CEL(check engine light) will stay on all the time.
You can send the Computer out to a programmer and they can remove the auto software from it, also give it a better tune for manual trans use
Are you reading your OTHER POSTS????
Like here: https://www.ranger-forums.com/member...-model-154165/
Where I answered it the first time you asked
Signal for that goes thru the DTR(digital transmission range) sensor, so you must have by passed it?
You need to do the same by pass on the DTR, so computer "thinks" transmission is in D-Drive.
There is no way to simulate automatic trans, so CEL(check engine light) will stay on all the time.
You can send the Computer out to a programmer and they can remove the auto software from it, also give it a better tune for manual trans use
Are you reading your OTHER POSTS????
Like here: https://www.ranger-forums.com/member...-model-154165/
Where I answered it the first time you asked
#6
RF Veteran
iTrader: (1)
Thread
Thread Starter
Forum
Replies
Last Post
BlackRanger04
Drivetrain Tech
26
12-05-2010 10:17 PM