I have what I believe to be a Dana 35 with 3:27 gears. The front differential is definitely blown not sure of the extent yet(plan on pulling the chunk on Tuesday) was wondering if anyone could link the correct ring and pinion and Locker. Thank you just bought the truck and found this when I got the correct u joint.

 

Welcome to the forum

Year of the Ranger would help

1997 and earlier used these: https://www.therangerstation.com/tec...les-1983-1997/

1998 and up used these: https://www.therangerstation.com/tec...xle-1998-2011/

Good place to see whats around your area here: https://www.car-part.com/
For whole axle setup

Axle ratio is on your driver's door label, under AXLE
Code list here: https://www.therangerstation.com/tec...ag-door-codes/
3.27 would be unusual, 3.73 or 4.10 were normally on 4x4s, but certainly possible

Ring and pinion gears are "reverse" or "normal" depending on year, so heads up