rear bumper won’t fit !
#1
rear bumper won’t fit !
hey guys new member here i just bought my first ranger and i had bought a new “off-road” bumper to put on the back of my 93 because the one it had was bent and this one is supposed to be a direct bolt on and the bumpers mounts are to wide for my bumper to bolt up any idea why ?
#2
RF Veteran
iTrader: (1)
Welcome to the forum
Not sure why it won't fit
Rangers used the same frame width 1983 thru 2011
1993-2011 regular beds were 2" wider than 1983-1992 bur frames were the same
There were different width bumper for Step-side beds, vs regular side beds, but attachment points were the same as far as I know
LMC Truck is a good site to check body part fitment between years: https://www.lmctruck.com/bumpers/rear-bumper
Not sure why it won't fit
Rangers used the same frame width 1983 thru 2011
1993-2011 regular beds were 2" wider than 1983-1992 bur frames were the same
There were different width bumper for Step-side beds, vs regular side beds, but attachment points were the same as far as I know
LMC Truck is a good site to check body part fitment between years: https://www.lmctruck.com/bumpers/rear-bumper
Thread
Thread Starter
Forum
Replies
Last Post