1994 Ford ranger xlt v6 4L supercharger
#1
1994 Ford ranger xlt v6 4L supercharger
So I was wondering if I could get a opinion on what I should do because I don’t know. So I’m thinking about putting a supercharger on my truck and I know I would put it on top of everything but there is no space in my engine bay and I really don’t wonna drive with a hole in my hood with it sticking out lol any help would be great
thwnks
thwnks
#2
RF Veteran
iTrader: (1)
You would do a Body Lift, one of the less expensive lifts you can do
You need to install the engine equipment FIRST, hood off
Get it running well
THEN use a straight edge to see how much LIFT you need to get clearance to close the hood
The body of the vehicle sits on 1" rubber mounts bolted to the frame, Body lift uses taller rubber mounts and longer bolts to lift the body higher above the frame
The engine sits on the frame so it stays where it is, just the body around it goes up
The steering shaft in engine bay and some wiring from body to frame will need to be dealt with, usually its not a big deal up to 3" lift
You need to install the engine equipment FIRST, hood off
Get it running well
THEN use a straight edge to see how much LIFT you need to get clearance to close the hood
The body of the vehicle sits on 1" rubber mounts bolted to the frame, Body lift uses taller rubber mounts and longer bolts to lift the body higher above the frame
The engine sits on the frame so it stays where it is, just the body around it goes up
The steering shaft in engine bay and some wiring from body to frame will need to be dealt with, usually its not a big deal up to 3" lift
Last edited by RonD; 04-30-2021 at 10:20 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Ford94Ranger
Snapshots
1
01-09-2020 10:01 AM
knick_knack
General Technical & Electrical
0
06-29-2017 03:32 PM