work i need
#1
work i need
I seriously debating getting rid of the truck here is the list let me know what you think. Me nor my work will be performing the work.
- Upper Control Arm assembly
- Lower ball joints
- Drive side axle
- Front wheel bearings
- Tie rod ends
- Alignment
Next 10,000 Miles
- Transmission torque converter
- Transmission fluid service
- Upper Control Arm assembly
- Lower ball joints
- Drive side axle
- Front wheel bearings
- Tie rod ends
- Alignment
Next 10,000 Miles
- Transmission torque converter
- Transmission fluid service
#7
Well, if your spending the coin to fix it, why trade? Everything that your complaining about would be fixed. If you just trade it away, your getting rid of the problems. However unless you keep quiet about the problems, you might not get a good trade in value for it. get a new one and use it an a dp which is only gonna net you like 5-6k.
#8
Well, if your spending the coin to fix it, why trade? Everything that your complaining about would be fixed. If you just trade it away, your getting rid of the problems. However unless you keep quiet about the problems, you might not get a good trade in value for it. get a new one and use it an a dp which is only gonna net you like 5-6k.
#11
ok so why get a new truck. You can get all the front end stuff minus the alignment shipped to your door for under $550 moog ties, balljoints and arms, timken bearings cardone cv. Ya the torque converter sucks but you can do that too. Why wont you or your work perform the work? You can practically do the whole front end in like 4 hours.
#12
ok so why get a new truck. You can get all the front end stuff minus the alignment shipped to your door for under $550 moog ties, balljoints and arms, timken bearings cardone cv. Ya the torque converter sucks but you can do that too. Why wont you or your work perform the work? You can practically do the whole front end in like 4 hours.
#14
#16
#17
#18
I don't think it's too far off.
Pretty sure those bearings are pretty expensive... you are 4x4 right? Probly close to $500 just for those if you need the whole hub.
Nevermind... maybe you are 2wd, haha. Shows how much I pay attention.
Pretty sure those bearings are pretty expensive... you are 4x4 right? Probly close to $500 just for those if you need the whole hub.
Nevermind... maybe you are 2wd, haha. Shows how much I pay attention.
#25