Hi guys I have always ordered ddm hid for years, this is the first with the ranger, they are already on, just need to mount/tie them off and just basically clean them up a bit so that they are neat, any tips, anyone have pics or would like to take pics and show off their skills, thanks so much .

 

i used 3m emblem tape on the back and stuck one under the horn mounting bolt on the flat part of the body and on the drivers side in front of the battery down behind the headlight

 

Here's where I mounted mine with screws so there not going anywhere!

Drivers side

Passenger side

And the relay for the Hi/lo kit on the core support

 

^^^same way i did mine when i had hi/lo

I have since switched to 55 watt heads with no hi/lo I was lazy and didnt want to take the intake and battery out so i did this



works just fine clears the hood with no issues

if you ordered the fogs too I believe i just cleaned the frame real well and used the 3m tape and then zip tied around them. no issues there either!

 

I appreciate the response, I a looking for a cleaner look in a more protected area, I may even buy some large heat stink and wrap them so that they are protected from water, too much debris and water can get under their where the fogs hid are, i love the battery and intake area, I will figure it out and get the results i'm looking for. Thanks a bunch men.