Reverse switch for 4X4
#1
10-12-2017
Join Date: Oct 2017
Location: northridge CA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Reverse switch for 4X4
I have no reverse lights in my 2011 Ranger 4X4 3.0 Manuel Transmission.
When I look for the switch on the transmission there are some other wires coming out of it as well that I assume are related to the 4WD.
Can anyone help me find the correct switch before I begin to make some serious mistakes.
The fuse and bulbs are fine.
Thanks.
When I look for the switch on the transmission there are some other wires coming out of it as well that I assume are related to the 4WD.
Can anyone help me find the correct switch before I begin to make some serious mistakes.
The fuse and bulbs are fine.
Thanks.
#3
10-12-2017
Transmission is farther forward, you are looking at transfer case
It is on drivers side almost at the top just in front of gear shifter
Unplug the two wire connector
Turn key ON
1 wire should now have 12 volts
Put a jumper wire between the two wires
Reverse lights should now be on
If so replace switch
It is on drivers side almost at the top just in front of gear shifter
Unplug the two wire connector
Turn key ON
1 wire should now have 12 volts
Put a jumper wire between the two wires
Reverse lights should now be on
If so replace switch
Thread
Thread Starter
Forum
Replies
Last Post
dogfish246
General Ford Ranger Discussion
0
10-10-2014 12:33 PM
Grande1972
General Technical & Electrical
0
03-10-2013 08:36 PM
Swoop1156
General Technical & Electrical
16
12-19-2005 08:42 PM
