What are the things I should replace? Putting in a used motor.
#1
What are the things I should replace? Putting in a used motor.
My 92 2wd distibuterless 2300 motor needs head work but I have a guy with a complete low mileage motor. I'm def doing timing belt and water pump and cleaning injectors and fuel rail and filter and clutch. Is there anything else I should consider? I'm not sure if this is the correct forum for this advise so I apologize. I also would like to know a good place to buy these items. Thank You.
#2
RF Veteran
iTrader: (1)
#3
When you pull the engine, inspect your tranny input items. If it's a manual, look at input shaft bushing/bearing(in crankshaft) along with throwout bearing and related items. If its an automatic, you could change the input seal. Like the old saying goes, an ounce of prevention is worth a pound of cure.
Thread
Thread Starter
Forum
Replies
Last Post
eBay / Craigslist Find: Used Alcoas, Brand new 15inch deer toes, Used MT Polished Classic IIs for CHEAP -OHIO
Masteratarms93
eBay & Craigslist Finds
7
05-09-2011 09:07 PM
03sonicblue4x4
General Ford Ranger Discussion
16
04-18-2010 11:58 PM