Well i have been wanting to do this build for a good little bit now. I just picked up A 96 ford ranger x cab step side black splash . the motor will be a ford 351w out of my old 95 ford bronco. So far i have yanked the motor and trans from the ranger. Got the 351w torn down. And hopefully i can get it back from the machine shop soon. today i got my fuel cell mounted. and tomorrow i will start to rip out the old wiring harness and start to rewire it.

Motor specs
351w roller motor with .030 over forged pistons.
stock crank and eagle I-beam rods.
holley 750 carb
Msd billet dis
Msd street streep ignition box
Edelbrok air gap intake
Ford GT40 heads

EZ wiring wire harness
think i may change my mind and go with a c4 instead of a t5
8.8 rear
oh and just a little shot to it too lol


Scott

 

Well.... where are the pics?!

 

so this is going to be street truck or offroad?

 

Be careful with yanking wires.I got a windsor in my 86 ranger and I still needed to use some of them.

 

Sory i have never updated this i have been busy with work.Well i got my block back i eneded up going a diffrent route. Well its all forged and troked to a 408 and got a set of AFR's and a c4. Rewired the whole truck from front to rear and made a a new instrument panel. it is coming along still need to get some parts tho. Just NO time to work on it tho. well here are some picks

 

nice man keep it up

 

So you have two tachs?

 

Yes i have 2. I had another smaller gauge in there and it didn't look good. So i used that as a filler for the panel. I think it looks good. My goal with this truck is to take it to the track and get kicked off for running to fast with out a cage lol.