SOHC - 2.3L & 2.5L Lima Engines Discussions and Topics specific to the Lima 4 cylinder engines

HELP!!!!! I changed the fuel injectors in my 93 ranger X and now the truck wont start

Thread Tools
 
Search this Thread
 
Old Feb 3, 2019
  #1  
Kelmers's Avatar
Thread Starter
|
Member
Joined: Oct 2018
Posts: 3
Likes: 0
From: Tyler tx
HELP!!!!! I changed the fuel injectors in my 93 ranger X and now the truck wont start

So I got new injectors but after I installed them the truck will not start I have every thing plugged in correctly but it seams that it is not getting fuel
 
Reply
Old Feb 3, 2019
  #2  
RonD's Avatar
RF Veteran
iTrader: (1)
Joined: Jan 2014
Posts: 30,635
Likes: 2,952
From: Vancouver, BC
Welcome to the forum

"Will not start" covers a bit of ground

When you turn the key does the starter motor work and crank/turn over the engine?

Since you say it's not getting fuel I will assume starter motor is working.

Fuel pump should run for 2 seconds each time key is turned on, and ONLY 2 seconds, listen for it.
Turn key on and off as much as needed to confirm you hear it running or confirm you don't
Fuel pump does NOT run full time until engine RPMs are above 400, so AFTER startup

On the fuel rail is a test port, looks like a tires air valve because that is what it is, a Schrader Valve
Works the same as tire air valve, press center pin and gasoline should squire out if fuel pump is working

The ICU(ignition control module) is on the front side of lower intake, this controls spark but.................it also sends timing plus to the engine computer so it can time fuel injectors, no timing plus = no fuel injectors
Make sure its plugged in well
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Wallyok
2.3L & 2.5L I4 Tech
21
May 31, 2022 08:38 AM
Vino634
DOHC - 2.3L Duratec / Mazda L Engines
18
May 10, 2022 12:00 PM
vin
General Technical & Electrical
2
Nov 21, 2018 04:16 PM
rpt50
SOHC - 2.3L & 2.5L Lima Engines
7
Nov 24, 2016 05:15 PM
taknotes
SOHC - 2.3L & 2.5L Lima Engines
11
Dec 2, 2014 01:02 PM




All times are GMT -6. The time now is 09:56 AM.